15 Reardon Road - Medford, MA - 02155
Tel.: (781) 396-0070 - Fax: (781) 396-8890

 
 
 
 
Drip Edge Metal

Drip Edge

Products custom made to order

This type of edge metal flashing is designed for installation on metal roofs as well as shingle, rubber or slate roofs. Drip edges are designed to steer water away from the edge of a building structure, protecting its rake and fascia board. They are also used to direct water into a gutter, for example.

Drip edge flashing metal parts are custom fabricated to any measurements and angles. These parts normally measure 10' in length but can also be bent in 12' lengths. We also manufacture radius drip edge flashing metal and can match any profile.

Riverside provides drip edge metal for general contractors, roofers and do-it-yourself home owners. Special pricing available for large quantities.
See images for installation method examples.

Riverside also offers installation services in Massachusetts and parts of of New England

Drip Edge - Profile 1

Angled drip edge
for metal roofing systems
10'-12' lengths

Drip Edge - Profile 2

Drip edge for shingle
and slate roofing
10'-12' lengths

Drip Edge - Profile 3

Straight drip edge
for metal roofing systems
10'-12' lengths

Drip Edge Flashing Metal is commonly fabricated with these materials:

Click here for a full list of colors and materials

Edge Metal and Flashing Metal fabrication & installation Gallery

Riverside Sheet Metal is a member of the North East Roofing Contractors Association Riverside Sheet Metal is a member of National Roofing Contractors Association

Riverside Sheet Metal is a member of the North East Roofing Contractors Association & the National Roofing Contractors Association.

SiteLock

Fully Licensed & Insured
MA HIC REG. #159489
MA CSL #CS40485